Nintex Network Ports

Default port configuration

Nintex's default port configuration is as follows. Server-side ports are fully configurable, and you can the opportunity to specify them during Nintex RPA Server installation.

For standard deployments (without SSL/TLS ):

Friendly name

Protocol

Server-side inbound port (configurable)

Client-side

outbound port

NGNIX port

HTTP

80

N/A

For SSL/TLS deployments:

Friendly name

Protocol

Server-side inbound port (configurable)

Client-side

outbound port

 

HTTPS

443

N/A

Discovery port

HTTP

80

N/A

For default ports only:  kryon\config\prod\general\db-model.json under updateLeoServers

If the port is 80 or 443, REMOVE it, and leave only the FQDN

Restart the services when its finished updating

TLS v1.3 is supported.

Opening ports

You can open the relevant ports during the Nintex RPA Server installation by selecting the "open ports" check box.

If you miss the selection, you can open the ports manually.

Open the following ports in both the Windows Firewall and your hardware firewall to prepare your network for Nintex installation:

  1. The ports listed in the relevant table above (or the port numbers you specified during Nintex RPA Server installation )

    Be sure to write down these port numbers; you will use them again!

  2. Port 8090 If you are installing with a multi-server configuration (i.e., with two Nintex RPA servers)

 

-Take me to the relevant step in the Nintex RPA Installation Guide-

-I came here while upgrading, take me back to the upgrading steps overview-