Nintex Network Ports
Default port configuration
Nintex's default port configuration is as follows. Server-side ports are fully configurable, and you can the opportunity to specify them during Nintex RPA Server installation.
For standard deployments (without SSL/TLS ):
|
Friendly name |
Protocol |
Server-side inbound port (configurable) |
Client-side outbound port |
|---|---|---|---|
|
NGNIX port |
HTTP |
80 |
N/A |
For SSL/TLS deployments:
|
Friendly name |
Protocol |
Server-side inbound port (configurable) |
Client-side outbound port |
|---|---|---|---|
|
|
HTTPS |
443 |
N/A |
|
Discovery port |
HTTP |
80 |
N/A |
For default ports only: kryon\config\prod\general\db-model.json under updateLeoServers
If the port is 80 or 443, REMOVE it, and leave only the FQDN
Restart the services when its finished updating
TLS v1.3 is supported.
Opening ports
You can open the relevant ports during the Nintex RPA Server installation by selecting the "open ports" check box.
If you miss the selection, you can open the ports manually.
Open the following ports in both the Windows Firewall and your hardware firewall to prepare your network for Nintex installation:
-
The ports listed in the relevant table above (or the port numbers you specified during Nintex RPA Server installation )
Be sure to write down these port numbers; you will use them again!
-
Port 8090 If you are installing with a multi-server configuration (i.e., with two Nintex RPA servers)
-Take me to the relevant step in the Nintex RPA Installation Guide-
-I came here while upgrading, take me back to the upgrading steps overview-