More About Object Blocks
The following properties (and, therefore, tabs in the Properties Pane) are relevant only to object blocks:
Object block position
Object block display
In Studio, the position of an object block is visible in the Display Pane, indicated by a blue dot and the purple block icon :
At wizard runtime, object blocks are:
-
invisible when run from Nintex Robot
-
indicated by a purple bounding box when run from Nintex Studio
Object blocks & object detection
Object block position is determined using object detection. Therefore, an object block's position properties are essentially identical to core action position properties – including the ability to apply an offset.
Viewing & customizing block location
The precise size and location of an object block is automatically detected when you create the block and/or apply an offset. You can view and edit this location as required.
To view the current location of the block:
-
Go the Position tab of the Properties Pane
-
In the Surrounding box section, click Show
The surrounding box appears temporarily (in orange) in the Display Pane.
To adjust the location of the block:
-
Go the Position tab of the Properties Pane
-
In the Surrounding box section, click Customize
The purple surrounding box appears in the Display Pane. -
Drag and resize the box as necessary
Restoring the default block location
To restore the default block location:
-
Go the Position tab of the Properties Pane
-
In the Surrounding box section, click Delete (use default)
The block is restored to its default location.
Object block fallbacks
The fallback event for an object block is:
-
Object not found
The default fallback command for this event is Retry
.
To change the default fallback command, follow the instructions in Applying Fallbacks.